Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
snow_height_sensor [2018/11/18 19:18] – [History] engollingsnow_height_sensor [2018/11/18 19:20] (current) – [Hardware assembly] engolling
Line 44: Line 44:
 Like all PCBs of the WeatherDuino system, you are free to install the connectors you prefer. Like all PCBs of the WeatherDuino system, you are free to install the connectors you prefer.
  
-<WRAP center round important 60%>+<WRAP left round important 60%>
  
 Be careful that the jumper for voltage selection is always set to 2.5V when using a HIREED LASER! Be careful that the jumper for voltage selection is always set to 2.5V when using a HIREED LASER!
  
 </WRAP>\\ </WRAP>\\
-<WRAP center round info 60%>\\+<WRAP left round info 60%>\\
 Since the Arduino and the LASER device have to talk to each other, the TX wire of the LASER has to be connected to the RX wire of the PCB and the other way round!\\ Since the Arduino and the LASER device have to talk to each other, the TX wire of the LASER has to be connected to the RX wire of the PCB and the other way round!\\
 </WRAP> </WRAP>

Trace:

Print/export
QR Code
QR Code snow_height_sensor (generated for current page)