Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| snow_height_sensor [2018/11/18 19:14] – [Software setup] engolling | snow_height_sensor [2018/11/18 19:20] (current) – [Hardware assembly] engolling | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| {{: | {{: | ||
| - | ====== WeatherDuino Snow Heigh Sensor ====== | + | ====== WeatherDuino Snow Height |
| + | |||
| ===== Overview ===== | ===== Overview ===== | ||
| Line 19: | Line 21: | ||
| After testing and debugging another summer, I now can proudly present you the automatic snow height measurement system for the WeatherDuino. | After testing and debugging another summer, I now can proudly present you the automatic snow height measurement system for the WeatherDuino. | ||
| - | |||
| - | __false__ | ||
| Line 44: | Line 44: | ||
| Like all PCBs of the WeatherDuino system, you are free to install the connectors you prefer. | Like all PCBs of the WeatherDuino system, you are free to install the connectors you prefer. | ||
| - | < | + | < |
| Be careful that the jumper for voltage selection is always set to 2.5V when using a HIREED LASER! | Be careful that the jumper for voltage selection is always set to 2.5V when using a HIREED LASER! | ||
| </ | </ | ||
| - | < | + | < |
| Since the Arduino and the LASER device have to talk to each other, the TX wire of the LASER has to be connected to the RX wire of the PCB and the other way round!\\ | Since the Arduino and the LASER device have to talk to each other, the TX wire of the LASER has to be connected to the RX wire of the PCB and the other way round!\\ | ||
| </ | </ | ||
| Line 128: | Line 128: | ||
| On the other hand some conditions might occur that don’t allows correct measurements for some time like very heavy snowfall or reflections of already fallen snow. I did not investigate those things, but I want to say that it’s important to choose the parameters according to your needs. I suggest a ratio that the filter is renewed between 40 and 60 minutes. | On the other hand some conditions might occur that don’t allows correct measurements for some time like very heavy snowfall or reflections of already fallen snow. I did not investigate those things, but I want to say that it’s important to choose the parameters according to your needs. I suggest a ratio that the filter is renewed between 40 and 60 minutes. | ||
| - | <WRAP center round tip 60%>\\ | + | **[[https:// |
| - | Further support und buying information may be found in the support forum.\\ | + | |
| - | </ | + | |
